The process of plastic pallet injection molding

The process of plastic pallet injection molding





The process of plastic pallet injection molding

Plastic pallet injection molding is performed in the following order: 1. Mold clamping, 2. Injection, 3. Pressure retention, 4. Cooling, 5. Mold opening, 6. Take out the product.
 
Injection molding machine can be divided into mold clamping device and injection device:
The mold clamping device is a direct pressure method that opens and closes the mold to perform the demoulding operation and uses the hydraulic cylinder to directly open and close the mold.

The injection device heats and melts the resin and then injects it into the mold. At this time, the screw needs to be rotated so that the resin put into the hopper stays at the front end of the screw, and is then injected after the required amount of resin is stored in the stroke. When the resin flows in the mold, the moving speed of the screw is controlled and the pressure (holding pressure) is used after filling the resin. When reaching a certain screw position or a certain injection pressure, switch from speed control to pressure control.

PLASTIC PALLETS PRODUCTION LINE -- Powerjet Supply Turnkey Solution of Logistics Pallet Manufacturing

 

Get In Tohch


Recommend Read

plastic pallet injection molding