How to control mold opening and closing of Standard Injection Molding Machine

How to control mold opening and closing of Standard Injection Molding Machine





Standard Injection Molding Machine mold opening control: the molten plastic is injected into the mold cavity until the cooling is completed, the mold is opened, and the product is pulled out. The opening process is also divided into three stages. The first stage opens slowly to prevent the product from tearing in the mold.

The second stage opened quickly and shortened the opening time. The third stage reduces the shock and vibration caused by opening inertia through slow opening.

Standard Injection Molding Machine clamping control:
The clamp is a huge mechanical thrust to tighten the mold, preventing high-pressure injection and charging of the molten plastic during the injection molding process, thereby creating a huge opening force for the mold. After closing the safety door, each travel switch sends out a signal, and the clamping action starts immediately. The first is to move the template, start at a slower speed, move forward a short distance, and then press the original slower switch to separate the lever pressure block to make the movable plate rotate forward quickly. When approaching the end effector, the pressure rod at the other end of the lever pressed the slow switch, and the movable plate slowly rotated again at this time, moving forward at a low pressure.

During the low-pressure clamping process, if there are no obstacles between the molds, it can be closed gently with a high-pressure switch. Rotating the high-pressure is to straighten the hinge of the machine to complete the clamping action. This distance is very short, usually only 0.3 ~ 1.0 mm. As soon as the high voltage is turned, the clamping end limit switch is reached. At this time, the action stops and the mold clamping process ends.

The clamping structure of the machine is fully hydraulic and machine connected. Regardless of the structure, the connecting rod will eventually be completely straightened and the joint main force will be implemented. The process of straightening the connecting rod is the process of opening the movable plate and the tail plate, and the process of increasing the force on the four levers.

The size of the clamping force can know the highest value that can be increased on the hydraulic gauge at the moment of tightening the clamping force. If the clamping force is large, the maximum value of the hydraulic system will increase, and vice versa. The small Standard Injection Molding Machine does not have a clamping hydraulic gauge, so it is necessary to judge whether the mold is really tightened according to the straightening of the connecting rod.

When a machine closes the mold, if the connecting rod cannot be easily straightened, "almost" straightened, or one of several pairs of connecting rods cannot be completely straightened, an expansion mold will appear during injection molding, and there will be flying in the production. Side or other issues

Get In Tohch


Recommend Read

STANDARD INJECTION MOLDING MACHINE